Routers are electrical devices which can be employed to allow a computer to access the world wide web. Basically, a router can be a barrier from the computer and also the web. That barrier actually will allow for your personal computer to communicate with the world wide web. There are several router manufacturers all over the world who produce these devices and then sell on them to clients, or even in many cases to telecom companies who distribute these to their users. Should your internet service provider gave you or sold a router, it will almost certainly come configured. Internet providers wish to not waste time and avoid hassle in order that they setup those routers before giving them to their users. However, in case you go and purchase a router in a store, you’ll have to configure it all on your own. This is not too hard knowing your work.
In order to configure a router, you obviously want to know how you can access that router and ways to get to its configuration panel. As mentioned before, there are numerous router manufacturers and they also don’t all utilize a standard IP address for accessing. There isn’t a global default IP address which all producers use. Instead, companies who make routers choose their default IP address by themselves. Naturally, the accessing IP will always be from the private IP block, spanning from 192.168.0.0 to 192.168.255.255. Typically the most popular router manufacturers are usually Cisco and Netgear. Those two companies use 192.168.1.1 his or her default accessing IP address. Therefore, in order to get on the configuration panel associated with a Cisco or Netgear router, you will have to visit your browser and type 192.168.1.1 in the address bar. It’ll probably ask you for a username and a password, that is typically set to “admin” and “admin” by default.
Other companies use other IP addresses. By way of example, TP-Link usually uses 192.168.1.254 for their default accessing address. Some companies use 192.168.0.1 or 192.168.100.1. It is almost always the truth that particular company uses one Ip for all those their routers, if you have in mind the access path for one Cisco router, it is the same for all of them. It is recommended that you read the manual from the particular router you purchased and locate the default Ip there.